ПОВЫШЕНИЕ ПРЕДЕЛЬНОЙ НАГРУЗКИ КЕРАМИЧЕСКИХ ВКЛАДЫШЕЙ ДЛЯ ЧАШЕК ПРОТЕЗОВ ТАЗОБЕДРЕННЫХ СУСТАВОВ ПУТЕМ ЗАДАННОГО СТОЛКНОВЕНИЯ С ТЫЛЬНОЙ СТОРОНЫ ВКЛАДЫША И ЧАШКИ ВЕРТЛУЖНОЙ ВПАДИНЫ
1. Cup (4) and insert (3) to (12) cup of a hip joint prosthesis, wherein the insert (3) is connected with a cup clamping cone (5) in the region of the conical clamping equator compound (7) of both components (3, 4), and in the state of no load on the insert (3) below the clamping cone (5) up to the pole (6) between two components (3, 4) is a slit (8) which is bounded by radial contours of both components (3, 4), wherein that the radial contours of the two components (3, 4) starting from the lower end of the cone (9) and to the pole (6), characterized Odinak ovymi geometric elements in the same sequence, and between the geometric elements transitions occur tangentially or approximately kasatelnoy.2. A cup and insert of claim. 1, characterized in that the gap (8) is the initial gap (8), the size of the largest in the absence of load on the insert (3), and when a load on the insert (3) size decreases and the starting with a certain load the slit at least partially closed so that there is a contact component (3, 4) including the lower clamping cone (5) .3. A cup and insert of claim. 2, characterized in that the width (10) initial gap (8) between the components (3, 4) in a state of no load on the insert (3) in the vicinity of the cone is less than the width of the gap in the pole (6) or equal ey.4. A cup and insert of claim. 2, characterized in that the width (10) initial gap (8) between the components (3, 4) in a state of no load on the insert (3), starting from the region near the cone, until the pole (6) umenshaetsya.5 constantly. A cup and insert of claim 1, characterized in that the cup (4) consists of metal and is formed Fineness1. Чашка (4) и вкладыш (3) для чашки протеза тазобедренного сустава (12), причем вкладыш (3) соединен с чашкой зажимным конусом (5) конического зажимного соединения в области экватора (7) обоих компонентов (3, 4), а в состоянии отсутствия нагрузки на вкладыш (3) ниже зажимного конуса (5) вплоть до полюса (6) между двумя компонентами (3, 4)
