1. The absorbent item (1) referred to in this specification includes a main body (2), whose upper leaves can be permeable to liquid (3),1. The absorbent core (5) between the rear wet liquid table (4) and the rear liquid table (3) and the rear liquid table (4),The main body (2) is installed along a longitudinal axis (Y1) and a transverse axis (x1), extending in a direction perpendicular to the longitudinal axis (Y1),This body (2) defines the front end (6),1. The next (7) and the crotch (8)；Clause (1) consists of the first wing (9) and the second wing (10), extending in the opposite direction from this part (2) of the main body in an asymmetrical manner with respect to the longitudinal axis (Y1),Usually along this transverse axis (x1),The wings (9, 10) are fixed by means of configured restriction means (11, 12), so that the wings (9, 10) are under pledge when bent on the main object (2) and the longitudinal axis (Y1). Each wing (9, 10) has an outer boundary (14), in which at least one arc (30) coincides with a section (31) of the outer boundary and has a certain radius (R),Section 31 extends from the first point (29) of the outer boundary to the second point (32) of the outer boundary, the second point (14) of the outer boundary, and the third point (30) of the outer boundary does not conform to the outer boundary (14),If you are already registered, please log in first. This note also refers to a method of manufacturing the type of absorbent (1) described above.RESUMEN La presente descripción se refiere a un artículo absorbente (1) que comprende un cuerpo principal (2) teniendo una hoja superior permeable a líquidos (3), una hoja posterior impermeable a líquidos (4) y un núcleo absorbente (5) atrapado entre dicha hoja superior (3) y dicha hoja posterior (4), dicho cuerpo principal (2) instalándose a lo largo de un eje longitudinal (Y1) y un eje transversal (X1) extendiéndose en una dirección perpendicular con relación al eje longitudinal (Y1), dicho cuerpo principal (
