A mixer sheath 200 for an intravascular catheter has a wall 210 patterned with lines of weakness 212 to cause buckling under longitudinal compression to form a blood mixing fin 211 extending radially outwards. The lines may be zigzag cuts extending through the full thickness of the tube wall and forming diametrically opposed mixing fins. The zigzag slits may be curved, to give fins with a curved outer edge, and vary in thickness (figure 4B). There may be longitudinally successive lines of weakness, with the thickness of the tube becoming successively greater so that the mixing fins form in sequence. The thickness of the sheath is no more than 0.5 mm and it may be formed from PEEK with one or more blood inlet ports. The lines of weakness may be formed using laser micromachining. An outer sheath 230 may enclose the mixer sheath. The fins mix blood from across the section of the vessel, for sampling by a blood sampling catheter inside the sheath.L'invention concerne des cathéters vasculaires, en particulier des systèmes de cathéters vasculaires (100) qui permettent de mélanger du sang. Selon certains aspects, l'invention concerne une gaine de mélangeur (110) destinée à un cathéter vasculaire, un procédé de fabrication d'une gaine de mélangeur, une gaine de cathéter, un cathéter, un procédé de déploiement d'un cathéter vasculaire, un procédé de retrait d'un cathéter vasculaire, un procédé de déploiement d'un ou plusieurs éléments de mélange de sang, un procédé d'utilisation d'un système de cathéter et un procédé d'inversion du déploiement d'un élément de mélange de sang. La gaine de mélangeur comprend un tube dont une paroi présente un motif de ligne de faiblesse (212) qui permet de provoquer une déformation d'une partie de la paroi de tube lorsqu'une force de compression longitudinale est appliquée au tube, en vue de former un élément de mélange de sang (111) qui s'étend radialement vers l'extérieur par rapport à un emplacement de la partie de la paroi du tube avant la