SLIDING AND SWINGING STRETCH AND TRACTION DEVICE FOR WHOLE VERTEBRAL COLUMN, BONES, JOINTS, LIGAMENTS AND MUSCLES WITH MAGNETIC FIELD FROM HEAD TO FOOT.
The swinging, sliding stretch and traction device for vertebral column, bones, joints, ligaments and muscles consists of three parts. 1) - Basic rectangular longitudinal frame, is of two large diameter pipes interconnected by two transverse pipes with cushion to lie down in supine and prone position. This said frame is mounted over two semicircular curvatures on both sides longitudinally for swinging movements to get effect of gravity and against gravity forces. In this basic frame, frame work of sliding system of smaller diameter pipes slides due to lever systems. Neck rest is mounted over the basic frame work at head end side and it is sliding with the help of pair of linkage connected to the pulling levers for neck traction in prone position. 2)-Sliding system is frame work of two pipes of smaller diameter, interconnected with two transverse pipes at leg end side of the device over which two foot rests are mounted for leg clamps. Vertical pipe is hinged at centre to one of the interconnected transverse pipes other end of said vertical pipe for pulling down, rope is tied. Said vertical pipe is kept normally in horizontal position by means of spring bias while swinging movements of the device. Pipes of this said frame slides in the pipes of basic frame while swinging movements. 3)-Lever system- attached to the semicircular curvatures of the basic frame on both side by means of an axle.
