Manufacturing procedure of an orthosis and corresponding orthosis obtained. The orthosis, obtained from a resin mold, plastic or similar material, includes a soft piece (1) that is arranged covering the foot and ankle, and a rigid piece (2) that is arranged on the soft piece (1 ), to give rigidity and control to certain areas of movement of the ankle and foot. The orthosis formed by the soft (1) and rigid (2) pieces includes a calcaneal window (7), a lateral maleolar window (3), a medial maleolar window, a scaphoid window and a cuboid window, defined in the soft part ( 1) flexible tabs with the ability to open and close for a correct and comfortable use as well as malleolar ailerons for a correct stabilization of the ankle in the coronal plane, also including a control zone of the metatarsal heads and the release areas that establish the windows Scaphoid and cuboid to allow movement of the medial half foot and half lateral foot, respectively.Procedimiento de fabricación de una órtesis y correspondiente órtesis obtenida. La órtesis, obtenida a partir de un molde de resina, plástico o material similar, incluye una pieza blanda (1) que se dispone cubriendo el pie y el tobillo, y una pieza rígida (2) que se dispone sobre la pieza blanda (1), para dar rigidez y control a ciertas zonas de movimiento del tobillo y pie. La órtesis formada por las piezas blanda (1) y rígida (2) incluye una ventana calcánea (7), una ventana maleolar lateral (3), una ventana maleolar medial, una ventana escafoidea y una ventana cuboidea, definiéndose en la pieza blanda (1) lengüetas flexibles con capacidad de abrirse y cerrarse para una correcta y cómoda utilización así como alerones maleolares para una correcta estabilización del tobillo en el plano coronal, incluyendo también una zona de control de las cabezas metatarsianas y las zonas de liberación que establecen las ventanas escafoideas y cuboideas para permitir el movimiento del medio pie medial y medio pie lateral, respectivamente.