[problem] of the above to cut both the upper and lower ends of the incense in sharp acute angle such cutting edge is easy to put the fire of the acute angle of the paper, under acute angle of incense holder container ash in the deeply piercing incense as wedge fallen become a prevention, so up and down the same acute angle to provide the incense that can mass production by the same cutting blade. A plurality of long incense sticks in the flow cutting device field to belt 11 , incense 13 by the cutting blade 14, which is set at an acute angle becomes the shape of an acute angle 2 is cut to incense. And then the cutting blade 14 through the belt to the dimensions of the provision to increase, by the lower side of the same sharp cutting blade 14 of incense 1, is disconnected from the incense sticks 2 , to enable the mass production this cutting process is repeated. Incense, sharp tip 2 above is easy to put fire, and since under are cut at an acute angle 2 at the same cutting blade 14, insert grab the incense 1 rather than stacking compression by the conventional bottom with a finger force in acute angle 2 wedge-shaped to destroy the ash, do not fall can be plugged into a deep ash.FIELD 7【課題】線香の上下両端を鋭い鋭角にカットして上の鋭角の紙の様な刃先は火が付け易く、下の鋭角は線香立て容器の灰に楔のように深く突き刺し線香の倒れ防止となり、上下同じ鋭角度なので同じ切断刃によって量産加工ができる線香を提供する。【解決手段】複数本の長線香はベルト11’に流れ切断装置場で、線香に対して鋭角にセットされた切断刃14により線香13がカットされ鋭角2の形状となる。次に切断刃14が上昇して規定の寸法にベルトが流れると、線香1の下側が同じ鋭角切断刃14により、線香2’と切断され、この切断工程が繰り返されて量産を可能にする。線香は、上の鋭角の先端2は火が付け易く、また下は同じ切断刃14で鋭角2’にカットしているので、従来の底面による積重圧縮はなく線香1を指で掴み差し込む力で鋭角2’楔状が灰を破壊し、深く灰に差し込む事ができ倒れない。【選択図】図7
