A total joint prosthesis joint, in which the concave cup (101; 201) and the convex components (102; 202) of the joint are partially congruent in an annular surface area (121; 221) of contact, where under high physiological loads, the annular surface area (121; 221) of contact defines a pool of closed volume fluid (130; 230) within the inner contour of the annular surface area of contact, and characterized in that the total joint prosthesis joint incorporates polymeric material on the side and that in the unloaded state, the annular surface contact area is reduced to form an interrupted surface area of contact by a smooth ripple in the shape of the cup over the contact area such that when the load it is high, the fluid is pushed out of the pool (130; 230), and when it is unloaded, the fluid is sucked back through the interruptions in the fluid pool (130; 230) by the elastic recoil of the components.Una articulación de prótesis total de articulación, en la que la copa cóncava (101; 201) y los componentes convexos (102; 202) de la articulación son parcialmente congruentes en un área superficial anular (121; 221) de contacto, donde bajo altas cargas fisiológicas, el área superficial anular (121; 221) de contacto define una piscina de fluido de volumen cerrado (130; 230) dentro del contorno interior de la área superficial anular de contacto, y caracterizada por que la articulación de prótesis total de articulación incorpora material polimérico bando y que en el estado sin carga, el área superficial anular de contacto se reduce para formar un área superficial interrumpida de contacto por una ondulación suave en la forma de la copa sobre el área de contacto de tal manera que cuando la carga es alta, el fluido es empujado hacia fuera de la piscina (130; 230), y cuando está sin carga, el fluido se vuelve a aspirar a través de las interrupciones en la piscina de fluido (130; 230) por el retroceso elástico de los componentes.